16

Jul

Aluminum Foil Roller For Home Or Restaurant

Aluminum Foil Roller For Home Or Restaurant

With the development of aluminum processing technology, the configuration of cold rolling mills is getting higher and higher. During the use of cold rolling work rolls, the roll surface will be embossed, sticked or changed grades. Generally, replacement is required. Re-grinding according to the process requirements can be used again, so the processing quality of roll grinding directly affects the surface quality and shape of the rolled material aluminum plate, so the requirements for the ground surface of cold-rolled work rolls are getting higher and higher. The operating skills of CNC roll grinders are also becoming higher and higher. As operators, in addition to hoping to have high-precision and stable machine tools, they also need to have highly intelligent grinding processes that can meet the requirements of roll grinding and can use good technology. Reliably control the grinding surface defects and meet the surface requirements of cold-rolled work rolls. When the CNC roll grinder is grinding the work rolls, the grinding amount of each work roll is around 0.10mm each time, the grinding time is about 1.5 hours, the surface roughness is different, and there are occasional network lines. The first pass rate is 96%. How to grind rolls with high efficiency and high quality? Can a set of highly intelligent grinding processes be invented to ensure the high-quality rolls required by the company's rolling mill? It is one thing that every roll grinder operator dreams of. Based on my 25 years of operating experience, the author qualitatively uses this "8-knife grinding method" to make the roll grinder grind cold-rolled work rolls intelligently.
 
HTMM you have seven tips for creating
aluminum foil rolls, so that you can use roll products safely and securely when using aluminum foil rolls.
1. After the start, the embossing roller can be pressurized when it reaches the specified temperature during operation.
2. The embossing shaft should be separated before the aluminum foil is embossed to avoid damaging the paper roll.
3. During the operation of the equipment, if there are inclusions and joints in the incoming materials, the embossing shaft should be separated. Prevent damage to the paper roll surface.
4. In the process of embossing production, the tension of the aluminum foil should be controlled properly. If it is too large, the pattern will be blurred, and it will be easy to wrinkle and stratify when it is too small.
5. If the embossing roller is stuck with aluminum foil or paper scraps, stop it quickly and brush it off with a copper brush. If the paper roll is stuck with aluminum foil or paper scraps, use a steel needle to remove the adhesive along the pattern.
6. The steel roller generates noise due to heat due to long working hours, and the aluminum foil sticks upward or waves appear. At this time, the embossing should be stopped and the roller should be ground with water to cool the roller.
7. After the embossing is produced for 150 hours, it must be molded again, and clean water must be sprayed during the molding process, and no alkali or hot water shall be used, which will reduce the service life of the paper roll.
 

BBQ Use Aluminum Foil Rolls The aluminum foil paper can be qualitative to ensure shading, no shedding, no light transmission, and no pollution

Related Products
Inquiry
If you have any questions, feedback or comments, please fill out the form below and we will reply you back as soon as possible.
Name:
*Email:
Tel:
Company name:
*Content: